8/15/2023 0 Comments Beamer powerpoint![]() ![]() Horizontally, there will be a black (invisible) edge on each side. In this situation, your slides are going to fit the projection vertically (in height). Your slides are 4:3 and the projector is 16:9 There are obviously two situations, both illustrated below. Here, it is important to discuss what happens if there is a mismatch between the aspect ratio of your slides and the one of the projector. Use 4:3 ratio or 16:9 ratio with increased font sizes. Most new projectors have a wide ratio, but check if possible. Everything will be as intended, the wall/screen area covered will be the largest, which gives the best immersion effect for your audience. Match the ratio of the projector/beamer.įor best result, always match the slide aspect ratio to the hardware. If you want to have the 16:9 ratio, but want to be safe for multiple presentations, then increase all font sizes. Use 16:9 ratio and increase font sizes.If you can’t get information on the ratio of hardware ahead of the presentation, or if you will be doing many presentations with the same slides, 4:3 ratio is a safe bet. Ahead of your presentation, check the ratio of the projector at the venue and match that. Match the ratio of the projector/beamer.I do presentations for a living and with close to 300 days of doing PowerPoint presentations in the last decade, here are my thoughts. But with the craze to wide-everything, is 16:9 slide presentation aspect ratio the best choice for all circumstances? Here are my thoughts. PowerPoint has switched to default 16:9 aspect ratio of the presentations a couple of years ago, which follows the trend of “wide-everything”, including smartphones, computer monitors, TVs, and projectors & beamers. The last point may not seem like much until you’ve tried to figure out how to include images in LaTeX.When designing a PowerPoint presentation, one of the first choices one makes is the slide size. Include multiple image formats in a consistent way.Carry around your entire presentation as a single file.Paste images directly into your presentations.The biggest advantage that PowerPoint has over LaTeX is working with images. ![]() I also like animating bullet points simply by adding pause to the end of an enumerated item. ![]() It’s nice to use real math typography rather than using PowerPoint hacks or pasting in LaTeX output as images. The Beamer package is simple to use and well documented. I found Bruce Byfield’s introduction to Beamer helpful. At least that was my experience using the graphical version. You just have to assume when it quits giving new messages that it must be finished. However, the MiKTeX Package Manager doesn’t let you know when packages have finished installing. The Package Manager shows no latex-beamer package, but does show a beamer package.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |